Post & Rail Pitch Fencing — Norvale Sport PVCu System

A Clean Pitch Boundary at Entry-Level Cost

The entry-level system. Three PVCu rails create a clean, defined pitch boundary — no mesh infill and no ball retention, but a professional white finish and zero maintenance at the most accessible price in the range. Ideal for community, junior and training ground applications.

✓ FA Step 7 minimum ✓ Community & junior ✓ Independently tested ✓ 15-Year Warranty ✓ Zero Maintenance ✓ Lowest cost per metre
⚠ Not suitable for FA Steps 1–6 or competitive rugby

Post & rail has no mesh infill and does not satisfy the permanent infilled barrier requirement at FA Steps 1–4, nor the permanent fixed barrier expectation at Steps 5–6. It meets the absolute minimum at Step 7 only. For any club in competitive football above Step 7, or any rugby club with National League ambitions, single mesh or double mesh is the right specification. We would rather tell you that here than quote you for something that fails an inspection.

White PVCu post and rail pitch perimeter fence bay with three horizontal rails and no mesh infill

A post & rail bay — three rails, no infill. Clean demarcation rather than containment.

Comparison of Norvale Sport double mesh, single mesh and post and rail PVCu pitch perimeter fence systems, showing mesh infill, FA step suitability, ball retention and supply price per metre

Pricing

Per linear metre of completed fence, ex VAT. Includes posts, rails and fixings. Gates and delivery are itemised separately on every quote and never folded into the metre rate.

Supply only
£49/m
Delivered to your ground
Installation
£28/m
Our managed teams
Supply & install
£77/m
Fully installed, ready for inspection

Single gate (1.5m) £500 · double gate (3.0m) £1,000 · delivery £500 flat with Moffett off-load. For a worked total on a standard pitch, see our 2026 price guide.

System Specification

SystemNorvale Post & Rail — 3-rail PVCu post and rail, no mesh infill
Mesh infillNone — the three rails alone form the barrier
Post127 × 127mm PVCu section, 1,800mm supplied length
RailPVCu extrusion, 2,449.2mm overall with a 38.1mm tenon at each end · 3 rails per bay · sliding mortise connection
Bay centres2,500mm
Barrier height1.1m to the top of the top rail, measured from the spectator side. The post stands 1,200mm above ground to the post top
Post hole300mm diameter × 750mm deep
Post embedment600mm · 150mm concrete base beneath the post, concrete surround to 150mm below ground level, 150mm soil backfill at the surface
Concrete per postApproximately 85kg — four to five 20kg bags
Thermal expansion gap10–12mm between rail sections at each post
ColourBright white PVCu · does not fade, yellow or discolour
Gate hardwareGrade 304 stainless steel throughout — hinges, latches, drop bolts
Gate modulesSingle 2,024mm overall (1,643mm clear) · Double 3,637mm overall (3,256mm clear)
TestingIndependently tested and audited — UV resistance, high temperature, low temperature, factory quality audit. UV weathering to ASTM G154 returned a colour change of ΔE 0.70 after 1,000 hours
Warranty15 years product warranty
Recommended setback2,250mm from the edge of the playing surface for football. Rugby run-offs are larger — see the rugby union and rugby league pages
Service optionsSupply only, UK-wide · Supply & install across the North of England and expanding

Full setting-out detail, including the foundation sequence and concrete quantities, is on our installation guide.

Suitable For

⚽

Football — FA Step 7

Meets the Step 7 minimum where post and rope would otherwise be used.

⚽

Football — grassroots

District, Sunday and junior leagues with no formal grading requirement.

⚽

Training pitches

Clear demarcation on training and warm-up areas at any level of club.

🏉

Rugby — community

Boundary definition at community level. Not suited to graded rugby grounds.

🏫

Schools & Academies

Safe, robust boundary for school pitches where ball retention is not required.

🏋

Leisure Centres

Tidy, low-cost demarcation for multi-pitch sites.

How It Compares to the Rest of the Range

Feature Double Mesh Single Mesh Post & Rail
This system
Meets FA Steps 1–4 infill requirement ✓ – –
Permanent infilled barrier ✓ ✓ –
Meets FA Steps 5–6 permanent barrier requirement ✓ ✓ –
Meets FA Step 7 minimum ✓ ✓ ✓
Ball retention Maximum High None — demarcation only
Spectator separation ✓ ✓ Minimal
Meets PLSF barrier criteria ✓ ✓ –
15-year warranty ✓ ✓ ✓
Independently tested ✓ ✓ ✓
Supply only, per metre ex VAT £59 £54 £49
Supply & install, per metre ex VAT £91 £84 £77

Frequently Asked Questions

Can we upgrade to mesh later?

Yes. All three systems share the same posts, rails, bay centres and foundations — the only difference is the infill. The practical constraint is that the rails must be drilled to take the mesh panels. If there is any chance you will want to upgrade, tell us at order stage and we will supply rails drilled for mesh at no extra cost, which makes a later upgrade a straightforward panel order rather than a rail replacement. Fitting mesh at installation is still cheaper than doing the job twice.

What does post & rail cost for a full pitch?

A standard 105 × 68m pitch with the barrier at a 2,250mm setback gives a gross perimeter of 364m. Gate modules are deducted from that, not added — two 3.0m doubles and two 1.5m singles take out 11.3m, leaving 353m of fence. At £77 per metre supplied and installed that is £27,181, plus £2,000 for the double gates, £1,000 for the singles and £500 delivery: £30,681 ex VAT. That is roughly £4,940 less than the same pitch in double mesh.

Can we get funding for post & rail?

Realistically, no. The Premier League Stadium Fund covers pitch perimeter barriers at Steps 1–6, and post & rail does not meet the barrier criteria at those steps. The Fund also does not fund work to meet Grade 7, which is where post & rail fits. The Football Foundation cannot fund pitch perimeter barriers at all. So a post & rail boundary is almost always club-funded, or funded through a County FA or local authority scheme. If grant funding is central to your project, that is an argument for specifying single mesh instead — the full funding guide explains the routes.

How long does installation take?

For a standard 11-a-side pitch of roughly 353m perimeter, a competent team of four with a mechanical post-hole borer typically completes installation over three days — posts on day one, concrete curing on day two, rails and gates on day three. Allow a minimum of 24 hours curing before loading the posts. Read the full installation method.

How does this compare to Duralock?

Both ranges are PVCu post and rail systems. Ours uses a 127 × 127mm post concreted into the ground, with bays at 2,500mm centres against 2,000mm on some competitors — fewer posts per pitch and less digging. On price, our supply-only rate sits below Duralock's reseller trade price of £59.80/m and around 14% below their retail list. Every order includes a drill jig for consistent fixing holes on site.

Get a Quote for Post & Rail Fencing

Tell us your perimeter length, sport and service preference. We respond within 24 hours with a full quote and specification document, free of charge.

Get a Free Quote Football Pricing & Steps