Skip to content
Fast, Nationwide UK Delivery — Calculated at Checkout
Premium Outdoor Products — Built to Last in UK Weather
Expert Advice — Call 01282 526 428 or Request a Free Quote
UK-Based Specialists — Ordering Made Simple, Support All the Way

How to Clean Composite Decking: A Step-by-Step Guide (Plus Winter Care)

by Brett Lockwood 20 Nov 2026

The best way to clean composite decking is simple: sweep it, rinse it, scrub it along the grain with warm water, mild washing-up liquid and a soft-bristled brush, then rinse again and let it air dry. That routine handles most dirt. Algae, grease and stubborn marks need a little more, and winter brings its own rules on snow, ice and de-icers. This guide covers all of it, so your composite decking keeps its colour and grip through the wet months.

Composite decking in a UK garden with black aluminium balustrade

What You Need to Clean Composite Decking

You do not need specialist kit. Most of this is already in the shed:

  • A soft broom or a leaf blower
  • A bucket of warm water and mild washing-up liquid
  • A soft-bristled brush (a long-handled deck brush saves your back)
  • A garden hose, or a pressure washer on a low setting
  • White vinegar and baking soda, for algae and stubborn spots
  • A household degreaser, for oil and grease

How to Clean Composite Decking, Step by Step

  1. Sweep. Clear loose dirt, leaves and debris with a soft broom or leaf blower. Move furniture and pots off the area first.
  2. Pre-rinse. Lightly hose the surface to loosen dirt. If you use a pressure washer, keep the nozzle at least 8 inches (about 20cm) from the boards.
  3. Wash. Mix warm water with mild washing-up liquid and scrub along the grain with a soft-bristled brush. Work in sections so the soapy water does not dry on the boards before you rinse.
  4. Rinse. Rinse thoroughly to remove all soapy residue. Soap left on the surface can leave streaks.
  5. Dry. Let the deck air dry naturally for a streak-free finish.
Tip: Clean the gaps as well as the boards. Always leave the gaps between boards clear so air can flow and water can drain. Blocked gaps hold moisture, and damp, shaded decks are where algae takes hold first.

Can You Pressure Wash Composite Decking?

Yes, but gently. Use a low setting and keep the nozzle at least 8 inches (about 20cm) from the surface. A garden hose and a brush will do the job on most decks, so treat the pressure washer as a quicker rinse rather than a way to blast off stains. Too much pressure, or a nozzle held too close, can mark the surface of the boards.

What not to use: bleach or bleach-based products, harsh chemical cleaners, abrasive cleaners and wire brushes. They can damage the composite and harm the plants around your deck. Avoid any abrasive tool that could scratch the boards.

How to Remove Algae, Moss and Mould From Composite Decking

Algae and moss are the main reason a composite deck turns slippery in autumn and winter. They grow fastest on damp, shaded boards and under trees. The RHS explains why green growth builds up on hard surfaces in shade and damp, and the same conditions apply to decking. Left untreated, it causes slippery patches, so deal with it as soon as you see it.

  1. Sweep the affected boards.
  2. Rinse with a hose or a low-pressure washer.
  3. Apply a vinegar solution of 2 parts white vinegar to 1 part water.
  4. For stubborn spots, sprinkle baking soda over the area, leave it for 15 to 20 minutes, then scrub gently with a soft brush.
  5. Rinse with fresh water.

If algae or moss keeps coming back, or you have marks that will not shift, contact our team for advice. That also applies to decks in coastal or very damp spots, where growth can be more persistent.

How to Remove Stains From Composite Decking

Food and drink

Act quickly. Most fresh spills come off with warm soapy water and gentle scrubbing.

Oil and grease

Barbecue fat and cooking oil need a household degreaser. Apply it, scrub lightly along the grain, then rinse well.

Persistent marks

Make a paste of baking soda and water, work it into the mark with a soft brush, then rinse. This lifts deeper stains without scratching the surface.

Scratches and scuffs

How you treat scratches depends on whether your boards are capped (they have a protective outer shell) or uncapped. Check your product page if you are not sure which you have.

  • Uncapped boards: light surface marks blend in naturally over time through weathering. If sanding is needed, use 60 to 80 grit sandpaper and always follow the grain.
  • Capped boards: the sanding advice in our care guide is for uncapped boards only, so do not sand capped boards without speaking to us first. Treat marks with the gentle methods above. Our capped composite decking has this outer shell.

Antique capped composite decking with a deep embossed woodgrain surface

Composite Decking in Winter: Snow, Ice and De-Icers

Winter is when composite decking needs the most care, because wet leaves, algae and ice all cut the grip underfoot. Our boards have a slip-resistant surface, but no surface stays grippy under a layer of leaves or ice.

  • Clear leaves quickly. Fallen leaves left on the boards hold moisture and cause mould and staining.
  • Use a plastic shovel for snow. Push the snow off gently rather than scraping at the boards.
  • Do not use rock salt or harsh de-icers. For grip, use sand or a salt-free de-icing product that is safe for composites.
  • Keep the gaps clear. Water that cannot drain will freeze on the surface.

How Often Should You Clean Composite Decking?

Composite decking needs far less upkeep than timber, with no sanding, staining or sealing. A seasonal routine keeps it looking its best:

Season What to do
Spring Deep clean to remove winter residue and check for drainage problems.
Summer Sweep regularly. Put protective pads under furniture to avoid scratches.
Autumn Clear fallen leaves quickly to prevent mould and staining.
Winter Plastic shovel for snow. Sand or a salt-free, composite-safe de-icer for grip. No rock salt.

Through the year, never drag heavy furniture or sharp objects across the boards. If your deck has a balustrade around it, give the posts and glass a wash at the same time. Our guide to decking balustrade ideas covers the options if you are planning an upgrade for spring.

Painting or staining: composite decking is designed to keep its colour without paint or stain. Boards could be coated after an initial weathering period of 8 to 10 weeks, but we do not recommend it, because it may affect performance and void warranty coverage.

Composite Decking Cleaning FAQs

What is the best way to clean composite decking?

Sweep, rinse, then scrub along the grain with warm water, mild washing-up liquid and a soft-bristled brush. Rinse off all the soap and let the deck air dry.

Can I use bleach on composite decking?

No. Bleach and harsh chemical cleaners can damage the composite and harm nearby plants. Use a 2:1 white vinegar and water solution for algae and mould instead.

Is composite decking slippery in winter?

Our boards have a slip-resistant surface, but algae, wet leaves and ice make any deck slippery. Clear leaves quickly, treat algae as soon as it appears and use sand or a salt-free, composite-safe de-icer in icy weather.

Can I put rock salt on composite decking?

No. Avoid rock salt and harsh de-icers. Use sand or a salt-free de-icing product that is safe for composites.

Planning a New Deck or a Spring Upgrade?

Browse our full composite decking range, with care and maintenance guidance on every product page. Need advice on cleaning a problem area, or on choosing boards for a damp or coastal garden? Contact us or call 01282 526 428.

Prev post
Next post

Thanks for subscribing!

This email has been registered!

Shop the look

Choose options

Edit option
Back In Stock Notification

Choose options

this is just a warning
Login
Shopping cart
0 items